Input Shaft Speed Sensor - 2

Input Shaft Speed Sensor - 2

WARNING: Before beginning any service procedure, REFER to Safety Warnings . Failure to follow this instruction may result in serious personal injury.

Material(s)






Removal

1. Disconnect the input shaft speed sensor 2 electrical connector.





2. Remove the input shaft speed sensor 2.

1. Remove the input shaft speed sensor 2 bolt.

2. Remove the input shaft speed sensor 2.

3. Remove the input shaft speed sensor 2 shim.






Installation

1. NOTICE: Make sure to use the 3.2 mm (0.126 in) input shaft speed sensor 2 shim or damage can occur to the transaxle.

NOTE: Install a new O-ring if installing the existing input shaft speed sensor 2.

NOTE: Use a small amount of Motorcraft(R) Dual Clutch Transmission Fluid on the input shaft speed sensor 2 O-ring for installation.

Install the input shaft speed sensor 2.

1. Install the input shaft speed sensor 2 shim.

2. Install the input shaft speed sensor 2.

3. Install the input shaft speed sensor 2 bolt.

- Tighten to 10 Nm (89 lb-in).





2. Connect the input shaft speed sensor 2 electrical connector.