without Door Modules (without Window One-touch Up)

Window Glass - Rear Door

WARNING: Before beginning any service procedure, REFER to Safety Warnings . Failure to follow this instruction may result in serious personal injury.

Removal

1. Remove the rear door trim panel. REFER to Door Trim Panel - Rear .

2. Position aside the rear door watershield.





3. Connect the window control switch.





4. Turn the ignition to the ON position.

5. Lower the window glass.





6. Remove the exterior door window glass belt moulding.





7. Position aside the door glass side run at the rear of the door.





8. Using a non-marring tool, remove the window extension.





9. Position the window glass to gain access to the window glass retaining tabs.

10. Insert a flat-blade screwdriver to release the window glass retaining tabs, while lifting the window glass upward.





11. Lift the window glass upward and remove the window glass through the exterior side of the door.





Installation

1. Install the window glass through the exterior side of the door.

2. Lower the window glass onto the window glass retaining tabs.

3. Turn the ignition to the ON position.

4. Lower the window glass.





5. Install the window extension.

6. Install the door glass side run at the rear of the door.

7. Install the exterior door window glass belt moulding.





8. Install the rear door watershield.

9. Install the rear door trim panel. REFER to Door Trim Panel - Rear .