Trim Panel: Service and Repair

TRIM PANEL
REMOVAL

(1) Disconnect and isolate battery negative cable.






(2) Using a small flat bladed tool or equivalent, press retaining clip upward through cutout in handle cover and remove cover. (Fig. 17)
(3) Remove switch bezel arid disconnect electrical connectors.






(4) Remove the screws. (Fig. 18)


(5) Remove mounting ring and remove window crank, if equipped.






(6) Open pocket door. (Fig. 19)






(7) Using a trim stick C-4755 or equivalent, separate window frame molding from door. (Fig. 20)






(8) Slightly pull door trim upward and swing away slightly.
(9) Unlock retainer clip and disconnect control cable, (Fig. 21)
(10) Remove trim panel
.
INSTALLATION
(1) Position trim panel and connect control cable.
(2) Install trim panel.
(3) Position window frame molding and seat clips fully.
(4) Close pocket door.
(5) Install window crank and mounting ring, if equipped.
(6) Install handle screws.
(7) Connect electrical connectors and install switch bezel.
(8) Install handle cover.
(9) Connect battery negative cable.