Fog/Driving Lamp Switch: Service and Repair

REMOVAL
1. Disconnect and isolate the battery negative cable.

Fog Lamp Switch:

2. Remove the cluster bezel from the instrument panel.

Fog Lamp Switch Remove/Install:

3. From the back of the cluster bezel, squeeze the two latches on the fog lamp switch body and push the switch out through the face of the bezel.
4. Remove the fog lamp switch from the face of the cluster bezel.

INSTALLATION
1. Position the fog lamp switch to the proper mounting hole on the face of the cluster bezel.
2. Using hand pressure, push the fog lamp switch firmly and evenly into the switch mounting hole of the cluster bezel until both of the latches on the switch body are fully engaged.
3. Reinstall the cluster bezel onto the instrument panel.