Fog/Driving Lamp: Service and Repair

FRONT LAMP UNIT

REMOVAL
1. Disconnect and isolate the battery negative cable.
2. Remove the front grille from the vehicle.

Front Lamp Unit Remove/Install:

3. Remove the two screws that secure the cover at the inboard side of the front lamp unit.
4. Remove the cover from the front lamp unit.
5. From the engine compartment, disconnect the vehicle wire harness connector from the connector receptacle for the front lamp unit.
6. Remove the four screws that secure the front lamp unit to the front of the vehicle.
7. Remove the front lamp unit from the front of the vehicle.

INSTALLATION
1. Position the front lamp unit to the front of the vehicle.
2. Install and tighten the four screws that secure the front lamp unit to the front of the vehicle.
3. From the engine compartment, reconnect the vehicle wire harness connector to the connector receptacle for the front lamp unit.
4. Position the cover to the front lamp unit.
5. Install and tighten the two screws that secure the cover at the inboard side of the front lamp unit.
6. Reinstall the front grille onto the vehicle.
7. Reconnect the battery negative cable.
8. Check and adjust the front lamp alignment as required.