Transmission Fill Procedure

NAG1 AUTOMATIC TRANSMISSION

STANDARD PROCEDURE - TRANSMISSION
FILL
To avoid overfilling transmission after a fluid change or overhaul, perform this procedure:
1. Verify that the vehicle is parked on a level surface.





2. Remove locking pin (1) (Fig. 139). Remove the plate of the locking pin with a suitable tool and press out the pin remaining in the cap downwards.
3. Remove cap (2).
4. Add this initial quantity of Shell\e1m(R)\e0m 3403 to transmission: Fig. 137 NAG1 Transmission Fill Graph
a. If only fluid and filter were changed, add 5.0 L (10.6 pts.) of transmission fluid to transmission. (b) If transmission was completely overhauled, torque converter was replaced or drained, and cooler was flushed, add 7.7 L (16.3 pts.) of transmission fluid to transmission.
5. Check the transmission fluid.