Rear Blower Motor

REMOVAL
1. Disconnect and isolate the battery negative cable.

Rear Roof Duct Panel:

2. Remove the rear dome light from the rear roof duct panel.
3. Disconnect the dome light wire harness connector and remove the dome light from vehicle.
4. Remove the six push-pin roof duct panel fasteners and remove the duct panel from the vehicle.
5. Remove the five evaporator panel screws at the front of the panel.

Rear Evaporator Panel:

6. If equipped, remove the interior motion sensor from the evaporator panel, disconnect the wire harness connector and remove the motion sensor from the vehicle.
7. Remove the three push-pin evaporator panel fasteners at the rear of the panel.
8. Remove the rear evaporator panel from the vehicle.

Rear A/C Blower Motor:

9. Disconnect the blower motor wire harness connector.
10. Remove the four blower motor retaining screws and the blower motor from the rear evaporator housing.

INSTALLATION
1. Install the blower motor to the rear evaporator housing and install the retaining screws. Tighten the screws to 5 N.m (45 in. lbs.).
2. Connect the blower motor wire harness connector.
3. Install the rear evaporator panel and the three push-pin fasteners.
4. If equipped, connect the interior motion sensor wire harness connector and install the interior motion sensor into the evaporator panel.
5. Install the five evaporator panel screws at the front of the panel. Tighten the screws to 2 N.m (17 in. lbs.).
6. Install the roof duct panel and six push-pin fasteners.
7. Connect the dome light wire harness connector and install the dome light into the rear roof duct panel.
8. Reconnect the battery negative cable.