Parking Brake Lever: Service and Repair

LEVER

REMOVAL
1. Disconnect the front brake cable from the pulley unit.
2. Remove the front brake cable from the hand brake lever (Fig. 29).





3. Remove the circle cover (Fig. 35).
4. Remove the bolts on the hand brake lever (Fig. 35).
5. Pull the cover off the hand brake lever (Fig. 35).
6. Disconnect the hand brake check switch and wiring harness from the hand brake lever (Fig. 35).
7. Remove the hand brake lever (Fig. 35).

INSTALLATION
1. Install the hand brake lever (Fig. 35).
2. Reconnect the hand brake check switch and the wiring harness to the hand brake lever (Fig. 35).
3. Install the cover to the hand brake lever (Fig. 35).
4. Install the bolts on the hand brake lever. Tighten to 25 Nm (221 inch lbs.) (Fig. 35).
5. Install the circle cover (Fig. 35).
6. Install the front brake cable to the hand brake lever.
7. Connect the front brake cable to the pulley unit (Fig. 35).