Operation CHARM: Car repair manuals for everyone.
Home >> Freightliner >> 2007 >> Sprinter 2500 V6-3.0L DSL Turbo >> Repair and Diagnosis >> Accessories and Optional Equipment >> Antitheft and Alarm Systems >> Service and Repair >> Installation
Manuals through 2025 now available!

Our trusted friends have launched a new website named LEMON, which has newer manuals. It also contains all the CHARM manuals.

LEMON is the spiritual successor to CHARM, I recommend you try it!

Link: lemon-manuals.la or lemon-manuals.org.ua

(Some people have issue connecting. LEMON is investigating. For now, use Firefox or change your DNS server)

Or, hide this message: temporarily or permanently

Installation






INSTALLATION





NOTE: The following procedure applies to center or rear intrusion sensors (also known as interior protection sensors). The front intrusion sensor and the inclination sensor are integral to the Roof Control Module (RCM) (also known as the Overhead Control Panel/OCP control unit or DBE), and are serviced only as a unit with the module.

1. Position the intrusion sensor unit (1) to its mounting location.
2. Reconnect the vehicle wire harness connector to the connector receptacle on the top of the sensor housing.
3. Engage the retaining tab on one end of the sensor housing into the edge of the mounting hole in the mounting bracket or the headliner, as the vehicle is equipped.
4. Push firmly and evenly upward on the other end of the sensor until the second retaining tab snaps into place within the mounting hole.
5. Reconnect the battery negative cable.
pro multis · About Operation CHARM