Operation CHARM: Car repair manuals for everyone.
Home >> Freightliner >> 2007 >> Sprinter 2500 V6-3.0L DSL Turbo >> Repair and Diagnosis >> Heating and Air Conditioning >> Evaporator Temperature Sensor / Switch >> Service and Repair >> Controls - Front >> Removal
Manuals through 2025 now available!

Our trusted friends have launched a new website named LEMON, which has newer manuals. It also contains all the CHARM manuals.

LEMON is the spiritual successor to CHARM, I recommend you try it!

Link: lemon-manuals.la or lemon-manuals.org.ua

(Some people have issue connecting. LEMON is investigating. For now, use Firefox or change your DNS server)

Or, hide this message: temporarily or permanently

Removal






REMOVAL

WARNING: Disable the airbag system before attempting any steering wheel, steering column, or instrument panel component diagnosis or service. Disconnect and isolate the negative battery (ground) cable, then wait two minutes for the airbag system capacitor to discharge before performing further diagnosis or service. This is the only sure way to disable the airbag system. Failure to take the proper precautions may result in accidental airbag deployment and possible serious or fatal injury.





NOTE: illustration shown with instrument panel top cover removed for clarity.

1. Disconnect and isolate the negative battery cable.
2. Remove the glove box from the instrument panel.
3. Disconnect the wire harness connector (2) from the front evaporator temperature sensor (1) located on the passenger side of the HVAC housing (3), just above the heater core tubes.
4. Using needle nose pliers or similar tool, carefully pull the front evaporator temperature sensor straight out of the HVAC housing.
pro multis · About Operation CHARM