Transmission Fill

TRANSMISSION FILL





To avoid overfilling transmission after a fluid change or overhaul, perform the following procedure:

1. Verify that the vehicle is parked on a level surface.
2. Remove locking pin (1). Remove the plate of the locking pin with a suitable tool and press out the pin remaining in the cap downwards.
3. Remove cap (2).
4. Add following initial quantity of required fluid to transmission:
a. If only fluid and filter were changed, add 5.0 L (10.6 pts.) of transmission fluid to transmission.
b. If transmission was completely overhauled, torque converter was replaced or drained, and cooler was flushed, add 7.7 L (16.3 pts.) of transmission fluid to transmission.
5. Check the transmission fluid and adjust as required.