Operation CHARM: Car repair manuals for everyone.
Manuals through 2025 now available!

Our trusted friends have launched a new website named LEMON, which has newer manuals. It also contains all the CHARM manuals.

LEMON is the spiritual successor to CHARM, I recommend you try it!

Link: lemon-manuals.la or lemon-manuals.org.ua

(Some people have issue connecting. LEMON is investigating. For now, use Firefox or change your DNS server)

Or, hide this message: temporarily or permanently

Blower Case Replacement

Air Distribution System Component View:




Blower Motor Case Assembly:






REMOVE OR DISCONNECT


1. Engine coolant.

- Drain enough coolant into a clean container to lower the coolant level below the level of the lowest heater hose fining.

2. Electrical connectors from blower motor (53) and resistor (80).

3. Blower motor (53).

4. Ground strap.

5. Heater hoses (72 and 70).

6. Screws (84).

7. Nuts (86).

8. Blower case (49) and seal (51).


INSTALL OR CONNECT

1. Blower case (49) and seal (51).

NOTICE: For steps 2 and 3, refer to "Fasteners" under "Vehicle Damage Warnings."

2. Screws (84).

- Tighten screws (84) to 3 Nm (27 in. lb.).

3. Nuts (86).

- Tighten nuts (86) to 3 Nm (27 in. lb.).

4. Heater hoses (72 and 70).

5. Ground strap.

6. Blower motor (53).

7. Electrical connectors from blower motor (77) and resistor (78).

8. Engine coolant.

- Use the coolant drained earlier only if it is uncontaminated. Discard contaminated coolant and add fresh 50/50 coolant and water mixture.