Ignition Coil: Service and Repair

REMOVAL:

NOTE: Make sure ignition switch is "OFF".

1. Disconnect wiring connectors at side of the coil.
2. Disconnect coil to distributor lead at coil.
3. Remove nuts or screws holding coil bracket and coil to engine.
4. Remove coil bracket and coil.
^ Drill and punch out rivets holding coil to coil bracket.
5. Remove coil from coil bracket.

INSTALLATION:

1. Install coil to coil bracket with screws.
2. Install coil and coil bracket to engine. Tighten screws to 22 N-m (16 lb. ft.).
3. Connect distributor lead to coil .
4. Connect wiring connectors to the coil.