Compressor Sealing Washers

Important
- When installing sealing washers, keep dirt and foreign material from getting on the sealing surfaces of the washers, hose block, or compressor ports. Clean all sealing surfaces with a lint-free rag.
- Do not reuse sealing washers.
- Sealing washers do not have to be oiled prior to assembly.

Install or Connect

Figure 18 - Sealing Washer Installation (1 Of 2):

1. Install sealing washer onto pilots of suction/discharge block fitting. Washers must bottom against surface of block fitting (Figure 18).

Figure 19 - Sealing Washer Installation (2 0f 2):

2. Install hose block to the compressor. Make sure the sealing washers are seated within the compressor machined surfaces (Figure 19).
3. Hold block in place, hand tighten bolt.

Tighten
- Bolt to 34 N.m (25 lb ft).