Oil Pressure Sensor: Service and Repair

Removal Procedure

^ Tools Required
- J 41712 Oil Pressure Switch Socket.





1. Remove the distributor. Refer to Distributor Replacement in Powertrain Management.
2. Disconnect the engine oil pressure gauge sensor electrical connector.
3. Hold the engine oil pressure gauge sensor fitting with a wrench.
4. Remove the engine oil pressure gauge sensor using the J 41712.





Important: Note the alignment of the engine oil pressure gauge sensor fitting prior to removal.

5. Remove the engine oil pressure gauge sensor fitting, if necessary.

Installation Procedure

^ Tools Required
- J 41712 Oil Pressure Switch Socket.

Notice: Refer to Fastener Notice in Service Precautions.





1. Install the engine oil pressure gauge sensor fitting, if removed.
1.1. Tighten the engine oil pressure gauge sensor fitting to 15 Nm (11 ft. lbs.).

Important: Do not loosen the fitting. Do not tighten the fitting more than one turn.

1.2. Tighten the fitting until properly align.





2. Install the engine oil pressure gauge sensor.
3. Hold the engine oil pressure gauge sensor fitting with a wrench to prevent from turning.
^ Using the J 41712 tighten the engine oil pressure gauge sensor to 30 Nm (22 ft. lbs.).
4. Connect the engine oil pressure gauge sensor electrical connector.
5. Install the distributor. Refer to Distributor Replacement in Powertrain Management.