Front Caster Adjustment

1. Remove the pinned adjusting cam insert. Do not reinstall the cam insert.
2. Loosen the upper control arm adjusting cam nuts.
3. Rotate the cam bolts to the required caster specification setting. Refer to Wheel Alignment Specifications (RWD Pick-up) or Wheel Alignment Specifications (4WD Pick-up) or Wheel Alignment Specifications (RWD Utilities) or Wheel Alignment Specifications (4WD Utilities).

Notice: Refer to Fastener Notice in Service Precautions.

4. Maintain the caster setting while tightening the cam bolt nuts.
- Tighten the nuts to 190 Nm (140 ft. lbs.).

Important: Verify the toe setting after changing the camber or the caster.

5. Verify the caster and the camber settings after tightening.
Verify the steering wheel pull specification after tightening
6. Readjust the caster and the camber setting if necessary.