Operation CHARM: Car repair manuals for everyone.
Home >> GMC >> 2000 >> K 2500 Truck 4WD V8-5.3L VIN T >> Repair and Diagnosis >> Powertrain Management >> Computers and Control Systems >> Accelerator Pedal Position Sensor >> Service and Repair
Manuals through 2025 now available!

Our trusted friends have launched a new website named LEMON, which has newer manuals. It also contains all the CHARM manuals.

LEMON is the spiritual successor to CHARM, I recommend you try it!

Link: lemon-manuals.la or lemon-manuals.org.ua

(Some people have issue connecting. LEMON is investigating. For now, use Firefox or change your DNS server)

Or, hide this message: temporarily or permanently

Accelerator Pedal Position Sensor: Service and Repair

REMOVAL PROCEDURE

NOTE: Refer to Handling Electronic Throttle Control Notice in Cautions and Notices.




1. Remove the left Instrument Panel (IP) lower closeout insulator panel.




2. Disconnect the electrical connector from the accelerator pedal sensor module.
3. Remove the accelerator pedal.

INSTALLATION PROCEDURE




1. Install the accelerator pedal to the steering column support bracket.

NOTE: Refer to the Fastener Notice in Cautions and Notices.

IMPORTANT: Always use a torque wrench in order to obtain the proper torque.

2. Install the accelerator pedal mounting bolts.

Tighten
Tighten the accelerator pedal mounting bolts to 20 N.m (15 lb ft).




3. Connect the electrical connector to the accelerator pedal sensor module.
4. Test for proper throttle opening and closing range by operating the accelerator pedal and monitoring the throttle angles using a scan tool. The accelerator pedal should operate freely without binding between full closed throttle and Wide Open Throttle (WOT).
5. Inspect the carpet fit under the accelerator pedal.
6. Install the left IP lower closeout insulator panel.
pro multis · About Operation CHARM