Fuel High Pressure Pipe Replacement - Pump to Rail

Fuel High Pressure Pipe Replacement - Pump to Rail

Removal Procedure




1. Remove the high pressure fuel pipe fastener (1).
2. Remove the center intake manifold. Refer to Center Intake Manifold Replacement (Service and Repair).




3. Remove the high pressure fuel pipe fitting (1).
4. Remove the high pressure fuel pipes (2) as an assembly.

Installation Procedure





Caution: Refer to Fastener Caution (Fastener Caution).

1. Install the high pressure fuel pipe fitting (1) and tighten to 30 Nm (22 lb ft).




2. Install the high pressure fuel fastener (1) and tighten to 10 Nm (89 lb in)
3. Install the center intake manifold. Refer to Center Intake Manifold Replacement (Service and Repair).
4. Start the engine.
If the engine does not start, repeat the above step.
5. Inspect the fuel system for leaks.