MP 3023/3024-NQH - Transfer Case

DTC C0569

Diagnostic Instructions

* Perform the Diagnostic System Check - Vehicle Diagnostic System Check - Vehicle prior to using this diagnostic procedure.
* Review Strategy Based Diagnosis Strategy Based Diagnosis for an overview of the diagnostic approach.
* Diagnostic Procedure Instructions Diagnostic Procedure Instructionsprovides an overview of each diagnostic category.

DTC Descriptor
DTC C0569 4B
- System Configuration Error Calibration Not Learned

Circuit/System Description

* This is an internal fault detection of the transfer case shift control module (TCCM). No external circuits are involved.
* This DTC is set anytime a TCCM is replaced or reprogrammed.
* The automatic transfer case (ATC) motor learn procedure must be performed in order for the TCCM to learn current clutch tolerance based on clutch stackup and accumulated clutch wear.

Conditions for Running the DTC

* Ignition ON.
* System voltage 10.5-18 V.

Conditions for Setting the DTC

The ATC motor learn procedure for a new or reprogrammed TCCM has not been performed.

Action Taken When the DTC Sets

* Mode shifting is disabled until the ATC motor learn procedure has been performed.
* The SERVICE 4WD indicator illuminates.
* No mode position LED's illuminated.

Conditions for Clearing the DTC

The TCCM clears the DTC once the ATC motor learn procedure has been successfully performed.

Reference Information
Schematic Reference

Transfer Case Control Schematics
Connector End View Reference

Component Connector End Views Connector End Views By Name
Electrical Information Reference

* Circuit Testing Circuit Testing
* Connector Repairs Connector Repairs
* Testing for Intermittent Conditions and Poor Connections Testing for Intermittent Conditions and Poor Connections
* Wiring Repairs Wiring Repairs

Scan Tool Reference

Control Module References Programming and Relearningfor scan tool information.

Circuit/System Verification

1. Key ON, engine ON. Let engine run for at least 1 minute.
2. Key OFF for at least 30 seconds to allow for the complete shutdown of the TCCM.
3. Key ON, engine OFF.
4. Verify that DTC C0387 is not set.

• If DTC C0387 is set, diagnose it first.

5. Verify that DTC C0569 is not set.

• If DTC C0569 is set, perform the ATC motor learn procedure. Refer to Transfer Case High/Low Clutch Reset .

Repair Instructions

Perform the Diagnostic Repair Verification Verification Tests after completing the diagnostic procedure.

Transfer Case High/Low Clutch Reset