Computers and Control Systems: Adjustments
IDLE SPEED CHECK AND ADJUSTMENTNOTE: Before starting engine place transaxle gear selector in Park (Neutral for M/T) and set parking brake and block drive wheels.
Accelerator Cable Adjustment:
1. Check accelerator cable for free movement and excessive play, cable play should be within specification.
2. Inspect lead wires and hoses of EFI and engine emissions control systems for secure connections.
3. Check ignition timing and adjust if necessary.
4. Turn "OFF" all accessories (A/C, wipers, heater, lights, etc.).
5. Make sure air cleaner is installed correctly.
6. Remove cover on idle speed adjusting screw.
7. Start engine and allow it to reach normal operating temperature (all accessories "OFF")
8. Connect a tachometer.
Diagnosis Switch Terminal:
9. Install a spare fuse to diagnosis switch terminal in fuse block.
10. Check idle speed, it should be:
A/T Metro LSI 700 +/- 50 rpm
A/T 850 +/- 50 rpm
M/T 750 +/- 50 rpm
Idle Speed Adjusting Screw:
11. If necessary, adjust idle speed by turning idle speed adjusting screw "IN" to increase or "OUT" to decrease idle speed.
12. Remove spare fuse from diagnosis switch terminal, disconnect tachometer and install idle speed screw cover.
A/C VSV ADJUSTMENT [A/C idle up solenoid]
VSV Component Location:
1. Start engine and allow it to reach normal operating temperature (with A/C "ON").
2. Connect a tachometer.
3. Install a spare fuse in diagnosis switch terminal.
Adjusting Screw For A/C VSV:
3. Check idle speed, adjust as necessary using the A/C vacuum switch idle screw. Idle should be:
A/T 850 +/- 50 rpm
M/T 900 +/- 50 rpm
4. Remove spare fuse from diagnosis switch terminal and disconnect tachometer from engine.