Vehicle Speed Sensor: Service and Repair

A/T Speed Pulser Removal/Inspection





1. Remove the 6 mm bolt from the transmission housing and remove the A/T speed pulser assembly.





2. Bring a magnet close to the A/T speed pulser assembly and check for continuity.

A/T speed pulser assembly is in good condition if there is:

- Continuity with a magnet close to the pulser assembly.
- No continuity with a magnet away from the pulser assembly.

If the A/T speed pulser is normal, go to ATV Pulser Rotor Disassembly/Inspection/Reassembly.

3. Replace the 0-ring with a new one before reassembling the A/T speed pulser.

CAUTION: Carefully inspect the All speed pulser before installing. Do not install it if it shows signs of being dropped or improperly handled.