Inspection Procedure

1. Set the parking brake, and turn the ignition switch to the ON (II) position.

2. Press the brake pedal, and move the shift lever to any position other than Park.

3. Try to turn the ignition switch to the LOCK (0) position and remove the key.

^ If you can remove the key, go to REPAIR PROCEDURE B.

^ If you cannot remove the key, go to step 4.

4. Remove the steering column covers. Refer to section 17 (Steering) of the appropriate service manual.





5. Check the manufacturer's name on the ignition switch assembly.

^ If the name is "HL-A," go to step 6.

^ If the name is "HONDA LOCK JAPAN," go to REPAIR PROCEDURE A.

6. Reinstall the steering column covers.





7. Center-punch a completion mark above the 15th character of the engine compartment VIN.