Center Lower Pocket

Center Lower Pocket Removal/Installation

SRS components are located in this area. Review the SRS component locations, precautions and procedures before performing repairs or service.

NOTE:
- When prying with a flat-tip screwdriver, wrap it with protective tape, and apply protective tape around the related parts, to prevent damage.
- Take care not to scratch the dashboard and related parts.




1. Remove the clips (A), and detach the clips (B) and tabs (C), then remove the center lower trim (D).




2. For '02-04 models with navigation system: Detach the clips, then remove the DVD panel (A).







3. Remove the center lower pocket (A).
1. Remove the screws.
2. Gently pull out along the top of the center lower pocket to release the clips.
3. Disconnect the center lower pocket light connector (B) (except '02-04 models with navigation system).

4. Install the pocket in the reverse order of removal, and note these items:
- Replace any damaged clips.
- Make sure the center lower pocket light connector is plugged in properly.
- Push the clips into place securely.