Center Pocket

Center Pocket Removal/Installation

SRS components are located in this area. Review the SRS component locations and the precautions and procedures before performing repairs or service.

NOTE:
- Put on gloves to protect your hands.
- Take care not to scratch the dashboard and related parts.

1. Remove the center holder.




2. Remove the center pocket (A):
1. Remove the screws (B).
2. Open the lid, then pull the pocket back by hand to detach the clips (C).
3. Close the lid, then remove the pocket.

3. Install the pocket in the reverse order of removal, and note these items:
- Make sure the holders (D) are installed onto the pins (E) properly.
- Push the clipped portions into place securely.
- Make sure the center pocket lid opens smoothly.