Operation CHARM: Car repair manuals for everyone.
Home >> Honda >> 2005 >> Civic Si L4-2.0L >> Repair and Diagnosis >> Powertrain Management >> Computers and Control Systems >> Testing and Inspection >> Scan Tool Testing and Procedures >> How to End a Troubleshooting Session
Manuals through 2025 now available!

Our trusted friends have launched a new website named LEMON, which has newer manuals. It also contains all the CHARM manuals.

LEMON is the spiritual successor to CHARM, I recommend you try it!

Link: lemon-manuals.la or lemon-manuals.org.ua

(Some people have issue connecting. LEMON is investigating. For now, use Firefox or change your DNS server)

Or, hide this message: temporarily or permanently

How to End a Troubleshooting Session

How to Reset the ECM




You can reset the ECM in either of two ways:

- Use the HDS or a scan tool to reset the ECM memory. See the HDS or a scan tool user's manuals for specific instructions.
- Turn the ignition switch OFF, and remove the No.6 ECU (ECM) (15 A) fuse (A) from the under-hood fuse/relay box (B) for 10 seconds.

How to End a Troubleshooting Session (required after any troubleshooting)

1. Reset the ECM as described above.
2. Do the ECM idle learn procedure.
3. Turn the ignition switch OFF.
4. Disconnect the HDS or a scan tool from the DLC.

NOTE: The ECM is part of the immobilizer system. If you replace the ECM, it will have a different immobilizer code. In order for the engine to start, you must rewrite the immobilizer code with the HDS.
pro multis · About Operation CHARM