Front Seat Disassembly/Reassembly - Manual

Front Seat Disassembly/Reassembly - Manual

Special Tools Required
KTC trim tool set SOJATP2014

SRS components are located in this area. Review the SRS component locations and the precautions and procedures before performing repairs or service.

The seat weight sensor (SWS) unit must be calibrated after any of these procedures:
- Front passenger's seat replacement (including any seat components)
- Replacement of the seat weight sensors
- Replacement of the seat weight sensor unit

NOTE:
- Use the appropriate tool from the KTC trim tool set to avoid damage when prying components.
- Route the seat wire harness correctly.
- Make sure the bushing and pivot washer are installed correctly.
- Apply multipurpose grease to the moving portion of the seat track.
- To prevent wrinkles in the seat-back cover, stretch the material evenly over the pad.
- If the seat-back pad or the OPDS unit is replaced with new one, reinitialize the OPDS unit.