AC Inverter Unit Input Test/Replacement

AC Inverter Unit Input Test/Replacement

1. Turn the ignition switch to LOCK (0).

2. Do the battery terminal disconnection procedure.

3. Remove the left rear side trim panel Interior Trim Removal/Installation - Rear Side Area.

4. Disconnect the 14P connector (A) from the AC inverter unit (B).





5. Inspect the connector and socket terminals to be sure they are all making good contact.

- If the terminals are bent, loose, or corroded, repair them as necessary, and recheck the system.
- If the terminals look OK, go to step 6.

6. With the connector still disconnected, do the following input tests:

- If any test indicates a problem, find and correct the cause, then recheck the system.
- If all the input tests prove OK, go to step 7.





7. Do the battery terminal reconnection procedure.

8. Reconnect the connector, and do the following input tests:

- If any test indicates a problem, find and correct the cause, then recheck the system.
- If all the input tests prove OK, replace the AC inverter unit.