Vehicle Cannot Be Started From D1

Vehicle Cannot Be Started From D1

SYMPTOM: Vehicle cannot be started from D1 on cruise test - Part 1.

DIAGNOSTIC PROCEDURE
1. CONFIRM THE SYMPTOM
Check if vehicle creeps in "R" position.
OK or NG
OK>> GO TO 2.
NG>> Refer to "Vehicle Does Not Creep Backward In "R" Position".

2. CHECK SELF-DIAGNOSTIC RESULTS
Execute self-diagnosis.
Is any malfunction detected by self-diagnostic results?
YES>> Check the malfunctioning system.
NO>> GO TO 3.

3. CHECK LINE PRESSURE
Check the line pressure at the engine stall point. Refer to "LINE PRESSURE TEST".
OK or NG
OK>> GO TO 4.
NG >> Check line pressure solenoid valve. Refer to "DTC P0745 LINE PRESSURE SOLENOID VALVE".

4. CHECK SYMPTOM
Check again.
OK or NG
OK >> INSPECTION END
NG>> GO TO 5.

5. PERFORM TCM INSPECTION
1. Perform TCM input/output signal inspection.
2. If NG, recheck TCM pin terminals for damage or loose connection with harness connector.
OK or NG
OK >> INSPECTION END
NG >> Repair or replace damaged parts.