Programming and Relearning
SETTING OF LIMIT SWITCHSetting of Limit Switch
If any of the following work has been done, set the limit switch (integrated in the motor).
- Removal and installation of the motor from the regulator.
- Operate the regulators as a unit.
- Installation of the new glass.
- Installation of the new glass run.
Resetting
After installing each component to the vehicle, follow the steps below.
1. Raise the glass to the top position.
2. While pressing and holding the reset switch, lower the glass to the bottom position.
3. Release the reset switch, and check the reset switch returns to the original position, and then raise the glass to the top position.
CAUTION: Do not operate the glass automatically to raise the glass to the top position.