Transmitter ID Registration Procedure
ID Registration ProcedureID REGISTRATION WITH ACTIVATION TOOL
This procedure must be done after replacement of a transmitter, BCM or rotating wheels.
1. Perform "CONSULT-II Start Procedure". Refer to GI-38, "CONSULT-II Start Procedure". Reading and Clearing Diagnostic Trouble Codes
2. Select "AIR PRESSURE MONITOR" on "SELECT WORK ITEM"
3. Touch "WORK SUPPORT" on "SELECT DIAG MODE" screen, and select "ID REGIST".
4. With the transmitter activation tool (J-45295) pushed against the front-left transmitter position of the air valve, press and hold the button 5 seconds.
5. Register the IDs in order from FR LH, FR RH, RR RH to RR LH. When ID registration of each wheel has been completed, turn signal lamp blinks.
6. After completing all ID registrations, press "END" to complete the procedure.
NOTE: Be sure to register the IDs in order from FR LH, FR RH, RR RH, to RR LH, or the self-diagnostic results display will not function properly.
ID REGISTRATION WITHOUT TRANSMITTER ACTIVATION TOOL
CAUTION: This procedure must be done after replacement of a transmitter, BCM, or rotating wheels.
1. Perform "CONSULT-II Start Procedure". Refer to GI-38, "CONSULT-II Start Procedure". Reading and Clearing Diagnostic Trouble Codes
2. Select "AIR PRESSURE MONITOR" on "SELECT WORK ITEM"
3. Touch "WORK SUPPORT" on "SELECT DIAG MODE" screen, and select "ID REGIST".
4. Adjust the tire pressure to the values shown in the table for ID registration, and drive the vehicle at 40 km/h (25 MPH) or more for several minutes.
NOTE: If ID registration is unable, buzzer beeps.
5. After completing all ID registrations, press "END" to complete the procedure.
6. Inflate all tires to proper pressure.