Operation CHARM: Car repair manuals for everyone.
Home >> Isuzu >> 2012 >> NPR-HD V8-6.0L >> Repair and Diagnosis >> Powertrain Management >> Fuel Delivery and Air Induction >> Fuel Tank >> Service and Repair >> Procedures >> Fuel System Cleaning
Manuals through 2025 now available!

Our trusted friends have launched a new website named LEMON, which has newer manuals. It also contains all the CHARM manuals.

LEMON is the spiritual successor to CHARM, I recommend you try it!

Link: lemon-manuals.la or lemon-manuals.org.ua

(Some people have issue connecting. LEMON is investigating. For now, use Firefox or change your DNS server)

Or, hide this message: temporarily or permanently

Fuel System Cleaning

Fuel System Cleaning

Fuel Tank Cleaning

CAUTION: Battery Disconnect Caution

IMPORTANT:
- Only use oil free compressed air to blow out the fuel pipes.
- Inspect the fuel tank internally and clean the fuel tank if you find a plugged fuel filter.

1. Disconnect the negative battery cable.
2. Relieve the fuel system pressure.
3. Drain the fuel tank. Fuel Tank Draining Procedure
4. Remove the fuel tank. Removal and Replacement
5. Remove the fuel sender assembly. Service and Repair
6. Inspect the fuel pump strainer. If the strainer is contaminated, replace the fuel pump.
7. Inspect the fuel pump inlet for dirt and debris. Replace the fuel pump if you find dirt or debris in the fuel pump inlet.
8. Locate a stand or fixture suitable to support the weight of the fuel tank and water.
9. Turn the in-frame rail fuel tank over so that the modular reservoir assembly opening is facing down.
10. Install side mounted fuel tanks upright and horizontal on stand of fixture and remove the drain plug and set aside for re-installation.
11. Turn the fuel tank over so that the modular reservoir assembly opening is facing down.

IMPORTANT:
- When flushing the fuel tank, handle the fuel and water mixture as a hazardous material. Handle the fuel and water mixture in accordance with all applicable local, state, and federal laws and regulations.
- Do not drill any access or drain holes in the fuel tank.

12. Using a high pressure water spray-wand, spray all interior surfaces with clean/non-contaminated water. Be sure to spray all internal tank surfaces including fore and aft sections of tank behind baffles, while allowing water to drain out modular reservoir assembly opening or drain hole. Perform each wash cycle for a minimum of 30 seconds using a minimum of 4 liters (1 gallon) of clean/noncontaminated water.
13. Using a high pressure air wand, dry all interior tank surfaces. Tank should be tipped accordingly to facilitate removal of water. Assure pressurized air does not contain any contaminants.
14. Repeat steps 10 and 11 for a total of 3 wash/dry cycles.
15. Hand dry tank surfaces with a white towel to confirm dryness and cleanliness. Use a non-metallic extension to push the towel beyond tank baffles.
16. If equipped with a fuel drain plug:
- Remove the old sealant from the drain plug male threads and tank drain female threads.
- Apply new (.05 mm thick) coat of sealant (P/N 9985253) to drain plug male threads and tank drain female threads.

NOTICE: Fastener Notice

- Install the tank drain plug.

Tighten
Tighten the tank drain plug to 54 N.m (40 lb ft)

17. Install the fuel sender assembly. Service and Repair
18. Install the fuel tank. Removal and Replacement
19. Refill the fuel tank.
20. Install the fuel filler cap.
21. Connect the negative battery cable.
22. Inspect for leaks:
22.1. Turn ON the ignition for 2 seconds.
22.2. Turn OFF the ignition for 10 seconds.
22.3. Turn ON the ignition.
22.4. Inspect for fuel leaks.
pro multis · About Operation CHARM