Rear Door Window Regulator

REMOVAL
1. Remove the trim panel and plastic water dam sheet.
2. Remove the window glass.

Window Regulator Rivet Locations:

3. Remove the regulator rivets by driving out the rivet center with a punch. Then drill out the rivet body with a 1/4 inch drill bit.
4. Disconnect the wire harness, if equipped.
5. Remove the regulator and window motor, if equipped.

INSTALLATION
1. Position the window regulator and window motor in the door.
2. Attach the regulator with new rivets or with screws and nuts available in a parts kit.
3. Connect all electrical wires.
4. Install the door glass and channel.
5. Install the weatherstrip and trim panel.