Seat Back Cover

SEAT BACK COVER

REMOVAL - REAR SEATBACK COVER

1. Remove the seatback from the vehicle.
2. Remove the seatback latch release handle and bezel from the seatback.
3. Disengage the cover zippers.

Fig. 10:

4. Disengage the J-strap attaching the cover to the seat back frame (Fig. 10).
5. Remove the cover from the seatback pad.

REMOVAL - BUCKET SEATBACK COVER

1. Remove seat.
2. Remove head restraint, if equipped.
3. Remove screws attaching side shield trim cover to bucket seat.
4. If equipped, disengage power seat wire connector from power seat switch.
5. Remove the inboard seatback pivot bolt and large plastic washer.
6. Position the seatback in the full forward or full recline position.
7. Remove the seatback cover J straps from the base of the seatback.

Fig. 11:

8. Roll the seatback cover upward, disengage electrical connectors for heated seat grid, if equipped. (Fig. 11).

Fig. 12:

9. Disengage the hog rings attaching the seatback cover to the seatback cushion support wires (Fig. 12).

Fig. 13:

10. Roll the seatback cover upward and disengage the hook and loop fastener (Fig. 13).
11. Roll seatback cover up and over the head restraint sleeves, if equipped and separate from the seatback.

INSTALLATION - REAR SEATBACK COVER

1. Install the cover on the seatback.
2. Attach the cover J-strap to the seatback frame.
3. Engage the cover zippers.
4. Install the seat latch release bezel and handle.
5. Install the seatback in the vehicle.

INSTALLATION - BUCKET SEATBACK COVER

1. Position the seatback cover on the seatback cushion and roll seatback cover down over the head restraint sleeves. Route the sleeves through the access holes in the cover, if equipped.
2. Roll the seatback cover downward and engage the hook and loop fastener. Engage electrical connectors for heated seat grid, if equipped.
3. Continue rolling the cover downward and engage the hog rings attaching the seatback cover to the seatback cushion support wires.
4. Engage the seatback cover J straps to the base of the seatback.
5. Install the inboard seatback pivot bolt and large plastic washer.
6. Install the side shield trim cover.
7. Install head restraint, if equipped.
8. Install seat.