Front Brake Rotor Match Mounting

If a front rotor is replaced it must be match mounted to the hub/bearing using the following procedure.
1. Install the rotor on the hub/bearing with a minimum of three washers and lug nuts. Tighten the nuts to 27 Nm (20 ft. lbs.).
2. Mark the rotor and one wheel stud.






3. Position a dial indicator 10 mm (0.40 inch) from the outer edge of the rotor.
4. Rotate the rotor and record the lateral runout reading.
5. Repeat the previous steps with the rotor install at all five possible positions.
6. Install the rotor on the hub/bearing in the location with the minimum lateral runout.

NOTE: Lateral runout should not exceed 0.05 mm (0.002 inch).