P0700

P0700-TRANSMISSION CONTROL SYSTEM (MIL REQUEST)

For a complete wiring diagram refer to the Wiring Information Electrical Diagrams.

- When Monitored:
Ignition on and battery voltage greater than 10 volts.

- Set Condition:
An active DTC is stored in the TCM. One Trip Fault. Three good trips to turn off the MIL.





Always perform the Pre-Diagnostic Troubleshooting procedure before proceeding. Pre-Diagnostic Troubleshooting Procedure.
DTC PRESENT IN EATX CONTROLLER
1. This is an informational DTC letting you know that a DTC(s) is stored in the Transmission Control Module.
2. Erase this DTC from the PCM after all Transmission DTC(s) have been repaired.
3. Using a scan tool, read the Transmission Controller DTC and perform the appropriate diagnostics.

PCM Diagnostic Information complete.

Continue

- Test Complete.