Operation CHARM: Car repair manuals for everyone.
Home >> Jeep >> 2009 >> Commander 4WD V6-3.7L >> Repair and Diagnosis >> Brakes and Traction Control >> Disc Brake System >> Brake Caliper >> Service and Repair >> Removal and Replacement >> Disc Brake Caliper - Installation >> Rear
Manuals through 2025 now available!

Our trusted friends have launched a new website named LEMON, which has newer manuals. It also contains all the CHARM manuals.

LEMON is the spiritual successor to CHARM, I recommend you try it!

Link: lemon-manuals.la or lemon-manuals.org.ua

(Some people have issue connecting. LEMON is investigating. For now, use Firefox or change your DNS server)

Or, hide this message: temporarily or permanently

Rear






REAR










1. Install the brake pads.
2. Lubricate the slide pins and slide pin bushings with caliper slide grease or the grease provided with the caliper.
3. Install the caliper (1) on the anchor.










4. Install the caliper slide pin bolts (4) and tighten to 25 Nm (18 ft. lbs.).

CAUTION: Verify that the brake hose is not twisted or kinked before tightening the fitting bolt.

5. Install brake hose (3) to caliper with a new gasket washers and tighten banjo bolt (5) to 31 Nm (23 ft. lbs.).
6. Remove the prop rod from the brake pedal.
7. Bleed the area of repair for the brake system, If a proper pedal is not felt during bleeding an area of repair then a base bleed system must be performed.Service and Repair.
8. Install wheel and tire assemblies.
9. Remove supports and lower vehicle.

pro multis · About Operation CHARM