Operation CHARM: Car repair manuals for everyone.
Home >> Jeep >> 2009 >> Commander 4WD V6-3.7L >> Repair and Diagnosis >> Steering and Suspension >> Steering >> Front Steering Knuckle >> Service and Repair >> Front Steering Knuckle - Installation
Manuals through 2025 now available!

Our trusted friends have launched a new website named LEMON, which has newer manuals. It also contains all the CHARM manuals.

LEMON is the spiritual successor to CHARM, I recommend you try it!

Link: lemon-manuals.la or lemon-manuals.org.ua

(Some people have issue connecting. LEMON is investigating. For now, use Firefox or change your DNS server)

Or, hide this message: temporarily or permanently

Front Steering Knuckle - Installation






INSTALLATION










1. Install the knuckle (1) to the vehicle.
2. Install the lower ball joint into the knuckle.
3. Install the lower ball joint nut. Tighten the nut to 95 Nm (70 ft.lbs.).





4. Install the upper ball joint (2) into the knuckle (3)
5. Install the upper ball joint nut (4). Tighten the nut to 95 Nm (70 ft.lbs.).










6. Install the outer tie rod end to the steering knuckle. Tie Rod End - Installation.





7. Install the hub/bearing (3), Tighten to 115 Nm (85 ft.lbs.). Front Hub and Bearing - Installation.
8. Install the axle shaft nut. Tighten the nut to 135 Nm (96 ft.lbs.).(if equipped with four wheel drive).

NOTE: Check the sensor wire routing (1). Be sure the wire is clear of all chassis components and is not twisted or kinked at any spot.

9. Install the wheel speed sensor (1) into the hub (3) and then install the mounting bolt (2) and tighten to 12-14 Nm (106-124 in. lbs.).Front.










10. Install the disc brake rotor (1). Brake Rotor - Installation.










11. Install the caliper adapter (1). Disc Brake Caliper Adapter - Installation.
12. Install the tire and wheel assembly. Removal and Replacement.
13. Perform wheel alignment Service and Repair.

pro multis · About Operation CHARM