Rear

REAR





1. Disconnect and isolate the battery negative cable.
2. Raise and support the vehicle.
3. Locate the rear axle sensor (5) on the forward pivot bracket for the rear axle right upper control arm.
4. Disconnect the vehicle wire harness connector (2) from the rear axle sensor connector receptacle.
5. Remove the screw (1) that secures the sensor link bracket to the bracket (3) on the rear axle right upper control arm.
6. Remove the two plastic push-pin fasteners (4) that secure the sensor mounting bracket to the forward pivot bracket for the rear axle right upper control arm.
7. Lower the sensor and bracket unit far enough to access and disengage the vehicle wire harness routing clips from the sensor bracket.
8. Remove the rear axle sensor, brackets and link from the vehicle as a unit.