Air Cleaner Body - Installation

INSTALLATION





1. Tilt the housing assembly (1) in the direction of the engine, lower and rotate toward the fender into position.





2. Install the housing assembly retaining bolt (1) located at the back side of the housing near the strut tower and tighten to 5 Nm (45 in. lbs.).





3. Install the housing assembly clean air tube (1).





4. Position the grille into the lower locating tabs, tilt the grille back and install the 6 retaining push pins (1).





5. Carefully position the air cleaner resonator (1) and connect the electrical connector at the Intake Air Temperature (IAT) sensor (2).
6. Lower the air cleaner resonator (1) into position.





7. Connect the air cleaner resonator air duct (3) onto the throttle body and tighten the air duct clamp (2) to 5 Nm (45 in. lbs.).
8. Install the air cleaner resonator retaining bolt (1) and tighten to 5 Nm (45 in. lbs.).





9. Position the engine cover (1) and secure the retaining grommets to the ball studs.






NOTE: Clean the inside of air cleaner housing before replacing the air filter element.

10. Install the air filter element into the housing assembly.
11. Position the air cleaner cover onto the housing assembly locating tabs.
12. Latch the 2 spring clips (4) and lock the air cleaner cover to the housing assembly.
13. Connect the make up air hose (3) to the air cleaner cover.
14. Connect the air duct (2) to the air cleaner cover and tighten the air duct clamp (1) to 5 Nm (45 in. lbs.).