Operation CHARM: Car repair manuals for everyone.
Home >> Jeep >> 2010 >> Commander 4WD V6-3.7L >> Repair and Diagnosis >> Starting and Charging >> Battery >> Service and Repair >> Removal and Replacement >> Battery - Installation
Manuals through 2025 now available!

Our trusted friends have launched a new website named LEMON, which has newer manuals. It also contains all the CHARM manuals.

LEMON is the spiritual successor to CHARM, I recommend you try it!

Link: lemon-manuals.la or lemon-manuals.org.ua

(Some people have issue connecting. LEMON is investigating. For now, use Firefox or change your DNS server)

Or, hide this message: temporarily or permanently

Battery - Installation






INSTALLATION





1. Clean and inspect the battery case, terminal posts and battery cable clamps, Cleaning.
2. Position the battery (1) into the vehicle. Ensure that the battery positive and negative terminal posts are correctly positioned. The battery cable terminal clamps must reach the correct battery terminal post without stretching the cables.
3. Install the battery hold down (4) by sliding it back and downward in the battery tray slots (3). Install the battery hold down bolt (2).






CAUTION: Be certain that the battery cable terminal clamps are connected to the correct battery terminal posts. Reverse battery polarity may damage electrical components of the vehicle.

4. Connect the battery positive cable terminal clamp (8) to the battery positive terminal post. Tighten the terminal clamp pinch-bolt hex nut to 5.5 Nm (50 in. lbs.).
5. Connect the battery negative cable terminal clamp (4) to the battery negative terminal post. Tighten the terminal clamp pinch-bolt hex nut to 5.5 Nm (50 in. lbs.).
6. Apply a thin coating of petroleum jelly or chassis grease to the exposed surfaces of the battery cable terminal clamps and the battery terminal posts.

pro multis · About Operation CHARM