C. (LC/LX) Dodge Challenger/Charger & Chrysler 300 WIN Replacement

1. Disconnect the battery negative cable.

2. Remove the end cap trim panel (Figure 3).

3. Remove the two screws from the knee bolster (Figure 3).

4. Remove the knee bolster cover (Figure 3).

5. Remove the knee bolster steel reinforcement located behind the knee bolster cover.

6. Using a trim stick or equivalent, gently pry along the edge of the trim to remove the instrument cluster trim (Figure 3).





7. Remove the four WIN mounting screws (Figure 4).

8. Remove the WIN from the rear of the instrument panel bringing it through the opening below the steering column and disconnect the electrical connector from the WIN.

9. Connect the electrical connector to the new WIN and position it back into the instrument panel.

10. Install the four WIN mounting screws through the instrument panel into the WIN and tighten securely (Figure 4).

11. Install the instrument cluster trim cover. Ensuring that the cover snaps into the securing clips.

12. Install the knee bolster steel reinforcement.

13. Install the knee bolster cover (Figure 3).

14. Install the two knee bolster lower instrument panel screws (Figure 3).

15. Install the end cap trim panel (Figure 3).

16. Connect the battery negative cable.

17. Continue with Section E. Obtaining Vehicle Personal Identification Number (PIN).