Ball Joint

Ball Joint Wear Limit





Check the ball joint for rotating torque.
If there is a crack in the dust cover, replace it and add grease.
Move the stabilizer link ball joint stud several times in a circular motion.
Mount the self-locking nut on the ball joint, and then measure the ball joint rotating torque.
Specified torque 1 - 3 Nm (10 - 30 kgf.cm, 0.72 - 2.17 ft. lbs.)

NOTE: Measure a torque by using the special tool (09532-11600) and torque wrench, at the range of 0.5 - 2 rpm after moving the ball joint stud 10 times at room temperature.

If the rotating torque exceeds the upper limit of standard value, replace the upper arm assembly.
Even if the rotating torque is below the lower limit of the standard value, the ball joint may be reused unless it has drag and excessive play.