Transmission Position Sensor/Switch: Service and Repair

Switch - Starter Inhibitor

Service Repair No - 44.15.19

Remove

1. Diesel models: Remove exhaust front pipe.





2. Move the selector lever to position 'P'.
3. Remove nut securing selector lever to gearbox selector shaft and release lever.





4. Remove 2 bolts securing inhibitor switch to gearbox.
5. Release multiplug from gearbox bracket.
6. Release inhibitor switch from selector shaft.
7. Disconnect switch multiplug and remove switch.

Refit

1. Ensure 'P' is selected by rotating selector shaft fully clockwise.
2. Engage 'N' by rotating selector shaft 2 detents anti-clockwise.
3. Position inhibitor switch to selector shaft, connect multiplug and secure multiplug to gearbox bracket.
4. Engage switch to selector shaft, and fit but do not tighten retaining bolts.
5. Fit tool LRT-44-011 to selector shaft.
6. Insert setting pin into tool. Rotate switch until setting pin engages with hole in switch as shown and tighten bolts.
7. Remove setting tool LRT-44-011.
8. Position selector lever to selector shaft and tighten nut to 26 Nm (19 ft. lbs.).