Sensor - Engine Coolant Temperature (ECT)

Sensor - Engine Coolant Temperature (ECT)

Service Repair No - 18.30.10

Remove
1. Disconnect battery earth lead.
2. Remove thermostat.





3. Disconnect multiplug from coolant temperature sensor.
4. Remove coolant temperature sensor and discard sealing washer.
5. Remove coolant temperature sensor from cylinder block.
6. Remove steel shim and sealing washer from temperature sensor, discard sealing washer.

Refit
1. Clean coolant temperature sensor and mating face on cylinder block.
2. Fit new sealing washer, then steel shim to coolant temperature sensor.
3. Position coolant temperature sensor and tighten to 17 Nm (12.5 ft. lbs.).
4. Fit thermostat.
5. Connect battery earth lead