Ignition Switch Lock Cylinder: Service and Repair

Ignition Lock Cylinder

Service Repair No - 57.40.28

Removal

NOTE: This procedure is for removal and installation of the ignition lock cylinder. The ignition lock and door lock cylinders are replaced in sets.

1. Fully extend the steering column for access.
2. Remove the steering column upper shroud.
^ Release the 4 clips.







3. Remove the steering column lower shroud.
^ Remove the 3 Torx screws.
^ Release the steering column adjustment lever.







4. Remove the passive coil.
^ Disconnect the electrical connector.
^ Release the 2 clips.

5. Remove the ignition lock cylinder.
^ Turn the ignition key to position 1.
^ Insert a pin, not exceeding 2 mm diameter, through the access hole in the ignition lock cylinder housing to depress the plunger, and release the ignition lock cylinder.







Installation

1. Install the ignition lock cylinder.
^ Turn the ignition key to position 1.
^ Locate into guides and depress the plunger.







2. Install the passive coil.
^ Secure the clips.
^ Connect the electrical connector.

3. Install the steering column shrouds.
^ Tighten the Torx screws.
^ Secure the clips.
^ Secure the adjustment lever.