Installation

INSTALLATION

NOTICE:
Never use SRS parts from another vehicle. When replacing parts, replace them with new parts.
Never reuse the airbag sensor assembly involved in a collision when the airbag has deployed.
Never repair a sensor in order to reuse it.









1. INSTALL AIRBAG SENSOR ASSEMBLY
a. Using a torx wrench, temporarily install the airbag sensor assembly with 3 torx screws.

Torx wrench: T40 (Part No.09042-00020 or locally manufactured tool)

b. Connect the connector.
c. Tighten the 3 torx screws.

Torque: 21 Nm (210 kgf.cm, 15 ft.lbf)

NOTICE:
- Installation of the connector is done with the sensor assembly installed.
- Make sure that the sensor assembly is installed with the specified torque.
- If the sensor assembly has been dropped, or there are cracks, dents or other defects in the case, bracket or connector, replace the sensor assembly with a new one.
- When installing the sensor assembly, take care that the SRS wiring does not interfere with other parts and is not pinched between other parts.
- After installing, shake the sensor assembly to check that there is no looseness.

2. INSTALL THESE PARTS:
a. Radio assembly
b. Upper console panel
c. Cup holder
d. Upper console panel rear
e. Shift lever knob