Driver Door Control System

If the jam protection does not function properly, perform the following procedure.

HINT: It is necessary to reset the power window motor (in the initial position for the limit switch) when separating the window regulator from the power window motor or operating the window regulator with the door glass not installed.

1. Remove the power window motor.

HINT: Place the matchmarks on the power window motor and window regulator gear.

2. Connect the power window motor and power window switch to the wire harness of the vehicle.
3. Turn the ignition switch ON and operate the power window switch to idle the power window motor in the up side direction for more than 6 rotations or less than 10 rotations (4 seconds or more).
4. Assemble the power window motor and regulator.

HINT:
- The motor should be installed when the regulator arm is in the middle, not around the upper end (more than 50 mm clearance is necessary from the upper end).
- Align the matchmarks on the power window motor and window regulator gear when installing the power window motor.

5. Assemble the power window regulator and door glass.

HINT: Never rotate the motor to the down direction until the installation of the window glass is completed.