Removal and Installation

Starter Part 1:

Starter Part 2:

Starter (part 3):

REMOVAL

1. REMOVE V-BANK COVER
2. REMOVE INTAKE AIR CONNECTOR
3. REMOVE INTAKE MANIFOLD ASSEMBLY
4. REMOVE STARTER




a. Remove the 2 bolts holding the starter to the cylinder block.
b. Disconnect the starter from the cylinder block.




c. Disconnect the starter connector.
d. Remove the nut, bolt and disconnect the starter wire.
e. Remove the bolt, and disconnect the engine wire protector from the starter.
f. Remove the starter.

INSTALLATION

1. INSTALL STARTER




a. Install the engine wire protector to the starter with the bolt.

Torque: 9.81 N.m (100 kg.cm, 84 in.lb)

b. Connect the starter wire with the nut.

Torque: 9.81 N.m (100 kg.cm, 84 in.lb)

c. Connect the starter connector.
d. Connect the starter to the cylinder block.
e. Connect the engine wire with the bolt.




f. Install the starter with the 2 bolts.

Torque: 39 N.m (400 kg.cm, 29 ft.lb)

2. INSTALL INTAKE MANIFOLD ASSEMBLY
3. INSTALL INTAKE AIR CONNECTOR
4. INSTALL V-BANK COVER