Speed Sensor, Front
SPEED SENSOR FRONT LHREPLACEMENT
HINT:
^ COMPONENTS Diagrams
^ Replace the RH side by the same procedures with LH side.
1. REMOVE FRONT WHEEL
2. REMOVE FRONT FENDER LINER LH
3. REMOVE SPEED SENSOR FRONT LH
a. Disconnect the speed sensor connector.
b. Remove the resin clip and 2 clamp bolts holding the sensor harness.
c. Remove the bolt and speed sensor.
NOTICE: Do not stick any foreign matter on the sensor tip.
4. INSTALL SPEED SENSOR FRONT LH
a. Install the speed sensor with the bolt.
Torque: 8.0 Nm (82 kgf-cm, 71 inch lbs.)
b. Install the sensor harness with the 2 clamp bolts and resin clip.
Torque: 5.0 Nm (51 kgf-cm, 44 inch lbs.)
c. Connect the speed sensor connector.
5. INSTALL FRONT FENDER LINER LH
6. INSTALL FRONT WHEEL
a. Install the front wheel with the 5 nuts.
Torque: 103 Nm (1,050 kgf-cm, 76 ft. lbs.)
b. Install the ornament with the 10 bolts.
Torque: 20 Nm (204 kgf-cm, 15 ft. lbs.)
7. CHECK ABS SPEED SENSOR SIGNAL