System Inspection
INSPECTION1. INSPECT MAIN SWITCH ASSY
a. Inspect the continuity between terminal at the each switch position shown in the chart.
If continuity is not as specified, replace the main switch assy.
b. Inspect the bulb state when connecting the battery to each terminal.
If operation is not as specified, check the faulty bulb.
c. Inspect continuity of the bulb by connecting the tester as shown in the illustration.
If continuity exists, replace the main switch assy.
If no continuity exists, replace the bulb.
2. INSPECT POWER POINT SOCKET RELAY
a. Inspect continuity between terminal at the each switch position shown in the chart.
If continuity is not as specified, replace the point socket relay.